Enduristan MONSOON EVO L 34 liter side bag

ATTENTION, the new MONSOON EVO are sold individually.

Developed over a period of almost two years with British rallyman and adventurer Lyndon Poskitt, Enduristan's new MONSSON EVO panniers meet rigorous specifications: a semi-rigid, waterproof, lightweight, easy-to-install and, above all, rugged luggage solution.

The Monsoon Evo allows you to travel as light as possible, thanks to its unbeatable empty weight of 2.75 kg for the L size.

There's no need to fit an adapter plate to the side supports: Monsoon Evo models have a built-in fastening system that clamps directly onto the side support hoops. Monsoon EVO can be fitted to all 18 mm tubular side supports.

The panniers are sold individually and can be mounted on either the left or right side of the motorcycle, ideally a SMALL on the exhaust side and a LARGE on the opposite side.

Like all Enduristan products, Monsoon Evo is waterproof. Your gear will stay dry and perfectly protected.

The materials used will withstand all the surprises the road can throw at you. The main material is Enduristan's usual three-layer textile, highly resistant to abrasion and totally waterproof. The fasteners on the side support hoops are made of reinforced composite fibers. Finally, a slider, also made of fiber, has been added to the outside of the frame, so that it touches the ground first in the event of a slip or fall.

A safety pin prevents the system from being accidentally unlocked, even in intense off-road conditions. This pin can be replaced by a padlock (not supplied) to secure the pannier to the bracket (ABUS 85/30HB65 format, for example).

Caution: if the panniers are too close to a heat source, it may be necessary to install two heat deflectors per side due to the high heat generated by the pot or manifolds. An easy rule to remember: if it's too hot for the hand, it'll be too hot for the panniers.

Dimensions MONSOON EVO LARGE:

- Volume 34 Litres
- Width 40 cm
- Height 40 cm
- Depth 21 cm
- Weight 2.75 kg

Features:

- Constructed from three-layer heat-sealed synthetic fabric and impact-resistant PVC:
> Inner layer in waterproof red vinyl for easy viewing inside the bag
> Intermediate layer of 1000D Nylon mesh sealed against tearing
> Extremely abrasion-resistant polymer outer layer
- Anti-impact PVC reinforcement to protect contents from stones and branches
- No adapters required
- No dangling straps
- Fits all tubular supports up to 18 mm.
- Protective slider
- Easy system release in seconds
- Perfect seal
- Roll-up closure + clips
- 4 compression straps
- 4 options on the short sides for attaching a bottle holder or universal case
- 2 rows of sewn-on straps at the top to secure additional equipment
- Ergonomic carrying handles
- Can be locked with ABUS 85/30HB65 size padlock (not supplied)
- Easy to clean

Accessories available separately:

- Shoulder strap, one strap per bag recommended
- Inferno heat shield
- Holds up to 6 internal storage bags
- For installation on short sides: bottle holder/universal case/mudguard bag L